Ich wollte schon länger ein Case für den Raspberry Pi 3 für den Prusa bauen. Der Raspberry Pi Zero wird nicht empfohlen weil n
Was baucht man alles:
- (6x) M3x10 screws (Salvaged from old part)
- (4x) M3nS nut (Salvaged from old part)
- (4x) M3n nut (Salvaged from old part)
- (4x) M3x10 screws
- (4x) M3 nut
- 6-8 x male-female jumper pins (Amazon: https://amzn.to/31OgRdL) or (RECOMENDED) Prusa i3 MK3(s) to Raspberry Pi connector cable (http://bit.ly/PiPrusaCable)
- Raspberry Pi 3B+ or 4B (Amazon 3B+: https://amzn.to/336YUr4 | Amazon 4B: https://amzn.to/2pH5x51)
- ≤ 8gb Micro SD Card (Amazon: https://amzn.to/2IrhsdU)
- A USB power supply (Pi 4 USB C: https://bit.ly/Pi4USBcPower) (Pi 3 Micro USB: https://bit.ly/Pi3microUSBpower)
- Angled Micro USB Extension for Pi 3 and below (Amazon: https://bit.ly/MicroUSBextension)
- Angled USB C Extension for Pi 4 and above (Amazon: https://bit.ly/USBcExtension)
*OPTIONAL Raspberry Pi Fan (Amazon: https://amzn.to/31Qk0dc)
(not necessary, however, as there is little airflow around the Pi this will likely prevent slowdowns and errors caused by thermal throttling)